Quote:
|
Originally Posted by greedyk
I found this aluminum bracket online.
They are made for Nissan 350Z.
They sell them plain also (no Z Logo). 23mm mirror shaft.
I had to make a small plastic spacer (to change the angle slightly) between the V1 mount and mirror bracket to make it work.
You use the original v1 mount and take suction cups off.
Screws attach V1 mount to bracket (they insert where suction cups used to be).
Not sure if I am allowed to show link on this thread because they are not a supporting vender!
http://www.countryjoycrafts.com/Conn...arDetector.htm
I hope you like it , I love it!
Gary |
About to pull the trigger for my V1 Gary! Can you post some pics? Also is it the 23mm or the 3/4 one? I am assuming you used the .23mm, was this why you had to use the plastic spacer? Can you elaborate on that and any tips on hardwiring? Did you use Inviscord? If so, is it necessary?
Thanks for the great tip!
Regards,
SRTHILL