|
Dyno #'s for B&G Stage 2 Flash on a stock SRT-8 - 30HP & 50LBs of Torque!
The numbers are in, the graphs are in...
I just got off the phone Dave and he will have the dyno charts shortly and I will post them up. The debate is over!
UPDATE: This is on a stock SRT-8 Charger with no Mods. Before you ask about the low stock SRT-8 numbers, I talked to the shop that did the Dynos this afternoon and these numbers are from completely heat soaked engines. They did admit that this SRT-8 heat soaked did show lower numbers than others they had dynoed. They had recently done a Dyno day and had several 5.7L's and a few 6.1L and there was a range of numbers from what is normally seen and some that were much lower depending on the degree of how Heat soaked the engine was.
Hopefully that addresses the question before it is asked...
HERE IS THE DYNO CHART

|
Last edited by Power Ported Performance : 10-09-2006 at 01:20 PM.
|