Quote:
Originally Posted by DaveW68
Is that dyno of a NA 6.4L engine? If so, that is very, very impressive. I wonder what they did with the internals to generate that kind of power? It just doesn't seem like it should be possible in a NA pushrod engine of that displacement. That engine must be sucking air like a mutha and the exhaust must be wide open. Not to mention some serious tweaking of the computer that we don't get in our 6.1's. And the torque figure is also very impressive. I can't wait to drive one when it comes out.
|
Available in Three Versions:
Aluminum Single-Plane High-Rise Intake Manifold with Holley 870 cfm 4-bbl Carburetor (540 hp)
Barrel-Shaped Tuned-Runner Intake Manifold with 80 mm Throttle Body for Electronic Fuel Injection (525 hp)
Hemi Long Block Crate Engine
Deep-Skirted Cast Iron Block with Cross-Bolted Mains
Bore: 4.055"
Stroke: 3.795"
CNC-Ported Aluminum Twin-Plug Cylinder Heads
Stainless Steel 2.100" Intake and 1.600" Exhaust Valves
Ovate Wire (Beehive) Valve Springs
Competition Viton Valve Stem Seals
279°/285° Hydraulic Roller Camshaft with 0.584 Intake and 0.552 Exhaust Lift
Forged Pistons
10.5:1 Compression Ratio
4140 Forged Steel Crankshaft
4130 Forged Steel 6.200" I-Beam Performance Connecting Rods
SFI-Approved Competition Crankshaft Damper
Plug-and-Play Wiring Harness
80 mm Manual Fuel Injection Throttle Body
Premium Tri-Metal Performance Engine Bearings
Precision-Balanced Rotating Assembly
Distributorless Coil-On-Plug Ignition System