|
Hid Retrofit Update
HI, I removed my test retrofit today and installed a complete OEM HID assembly. The only thing to do is remove the halogen assembly and install the HID one and connect the OEM wiring harness low beam connector to the HID connector on each assembly.
Or you could found the same connector that came on the HID equipped car and spliced it and connect.
Here a few photos for the connection. The connector needs to be put as shown (snap in top) because thats the right polarity.
The HID assembly connector is the gray one at the right top:
Here the OEM wiring harness low beam connector attached to the HID assembly connector:
__________________
2005 300C HIS, DLR, WOOD TRIM, D2S HID, PILLAR SET, AIR DEFLECTORS, LIP SPOILER, TINTING, E&G GRILL, LOWER MESH INSERT, PAINTED ENGINE COVER, VES, AIRHAMMER, UC, UNDERHOOD LIGHT, BFG KDWS 245/55/18, PEDALS SET, CHROME TAIL BEZEL
2005 300C HER, DLR, OEM HID RETROFIT, PILLAR SET, AIR DEFLECTORS, WOOD TRIM, LIP SPOILER, TINTING, OEM CABIN FILTER RETROFIT, E&G GRILL, LOWER MESH INSERT, PAINTED ENGINE COVER, VES, AIRHAMMER, UC, UNDERHOOD LIGHT, BFG KDWS 245/55/18, PEDALS SET, CHROME TAIL BEZEL
Last edited by HERMINIO : 03-11-2007 at 04:27 PM.
|
