STEP 4
You will now be able to undo the harness. There is a
RED clip located on the body of the harness which will
slide open if you push it inward into the harness.
AFTER IT UNCLIPS
STEP 5
Remove the tail light from the vehicle. No need to remove bulbs or screws. The new Altezza will include these already installed in the new light.
STEP 6
Now you will connect the harness to the new tailight. Snaps into place easily! Line up the
three screws on the new tail ight with the holes in the trunk and guide the tail light into place.
Once the light is in place on the car, began tightening the knobs back onto the original sites. Tighten them individually and re-tighten them until there is no gaps located along the body of the car.
caution: Do Not overtighten or use a wrench to help you!
After everything is tighten, put the carpet back in its original place and you are
DONE!