Content Wrapper

[jhelmuth]

Step 4 – Routing the TVandNav2Go Interface cable



[1] Take the interface cable (black casing with a DB-9 connector on one end) and “thread” the cable through any appropriate opening in the Nav unit casing such that you can easily route the colored wires to the Display Assembly without much trouble (you may want to use the routing I chose – see pix).


[2] While not necessary, I attached a tie-wrap to the end as a strain-relief

[3] Pull enough of the cable through to allow easy manipulation and attachment in the proceeding steps.

Note: to make routing easier, I removed the 9 screws from the front display assembly mounting plate. You may decide it works for you as well, but is not necessary (or you may choose to rout your cable differently than mine).