Hi Jim
Excellent write up. Just 1 note you should also ground the shield wire to prevent a ground loop.
Thanks Dominic of
www.TVandNav2Go.com 
Quote:
|
Originally Posted by jhelmuth
Step 5 – Re-assembly
[1] Reconnect the small black wire from step 3.3 (above).
[2] Making sure that the wire pairs are not in the way, carefully re-attach the Display assembly to the 3 connectors of the Nav unit.
Note: you’ll have to carefully “manage” the TVandNav2Go interface cable back out so that the assembly will not “pinch” the interface cable and/or the interface cable will not prevent the assembly from properly re-connecting.
[3] Replace the 4 phillips pan-head mounting screws from step 3.1 (above).
[4] Carefully replace the front bezel – it should “snap” in place – and replace the 4 top and 8 side bezel screws from steps 2.3 and 2.4 (above)
[5] Replace the Vol and Tune knobs. Make sure they are all the way in – there is no particular orientation here.
[6] Replace the joy-stick knob. This one has an orientation to it. Note the flat part of the shaft where it joins to the “notched” part of the knob, DO NOT force this. If it does not go on without extreme force, it is not oriented correctly. Re-evaluate the orientation and try again.
That should be it! You’re all ready to test the unit an complete the install!
|