Chrysler 300C & SRT8 Forums banner

Help please - power loss

2K views 2 replies 2 participants last post by  padpadpadpad 
#1 ·
Hi Guys,
Lost all power in my 300C CRD 1997 - I have the following codes stored

P0234 - Turbo/supercharger overboost condiition
P0046 - Turbo/supercharger boost control solenoid range / performance
V0106 - lost communication with glow plug control module

HELP !!!!

I thought it was the swirl motor - after taking the plug off and doing the "resistor" trick it's just the same ...... so I dont think it's that.

Is my only option here to take it to the dreaded STEALERS ?
 
#2 ·
re P0046 T/Super Charger Boost Ctrl Solenoid Circ Range/Perf

quick thought, remove engine cover, and whilst someone else turns ign key to on position, (not started)
have a look to see if your turbo actuator (black box on side of turbo) arm moves when key turned,
then start the engine, and give it a couple of revs, again see if arm moves.
if not, the actuators can be repaired, ECUtesting is the place i used
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top