Fault Codes P0046 and P0673 - CRD Turbo

[UK CHRYSLER 300C]

try again....lol

[Simon@thecustom300cshop]

Originally Posted by AgentE

I contact wtih Viezu.They said pls check DTC Codes.And i saw P0046 !!!
Tomorrow i hope i should apply algorithm.(once test drive check code if i see again i'll back stock mode.)
Thanks

Have you tried putting your stock map back on the car, deleting the fault code and driving it? It sounds like it may be a problem with the turbo actuator or its wiring.

[AgentE]

I delete code and tested my car today.I went to Chrysler Service and we looked also with Startscan no faulty code like P0046.
But i think have gearbox problem...I dont know how to explain to you but gearbox on D mode when i go about 80km/h rpm around 1500 if i speedup slowly my car makes a vibration...if i floor it rpm goes quickly and no vibration on my car.
I suppose its about gearbox torque converter maybe not...is there any idea?
Thanks

[UK CHRYSLER 300C]

I take it they did check the gearbox oil level to start with?... I'm sure they did, didn't they!... did they say anything about the box or was that your saying about the box.... Soz about that I think I may have jumped in too quick... again... lol

[Simon@thecustom300cshop]

Your right Ray, it sounds like the transmission fluid is low.

[UK CHRYSLER 300C]

not too sure Simon,my 3.5 v6 customers box loses a bit of gear oil and when his goes low it doesnt seem to move till he hits 2500 rpms and then sort of slips,he has a bad leak at the back of his box and he doesnt want it fixing,he's now sold it

[dadsincharge]

I've had a similar issue with mine. I cleaned the maf and so far it seems okay but i checked the codes tonight and had the P0046. I've cleared it and I'll monitor it. May go back to stock map to see if it reoccurs

Sent from AutoGuide.com Free App