Did u notice this with ur e&g grill?

[300 on 22s]

that the bottom 4 screws do not go into the locations i guess it doesnt matter cause the bottom 3 pegs is what holds it in just wondering if i was the only one who cont get the bottom studs in the holes

[wesexcellence]

Originally Posted by 300 on 22s

that the bottom 4 screws do not go into the locations i guess it doesnt matter cause the bottom 3 pegs is what holds it in just wondering if i was the only one who cont get the bottom studs in the holes

Did you open the holes? Once you do, they will fit and the nuts go after the large washers.

[300 on 22s]

yes im talking about the botom 4 where u dont put the nuts and washers

[wesexcellence]

Originally Posted by 300 on 22s

yes im talking about the botom 4 where u dont put the nuts and washers

I still think I had to open the holes for the bolts to seat properly.

[300 on 22s]

well the bottom ones dont get lockd in ne ways so i guess it dont mater

[wesexcellence]

Originally Posted by 300 on 22s

well the bottom ones dont get lockd in ne ways so i guess it dont mater

Just as long as it's even top to bottom and side to side. It should press in and fit snuggly with the provided seal.