Grille Wings and Custom Emblem Need Help

[cheifsfan]

OK I got the startech grille installed tonight. It looks amazing! Anyways It came with the OEM wing with the chrysler emblem. I have a emblem with the word "300" on order. Can I rip the chrysler emblem off and put it on? How do I do that? If not where can I order OEM wings without the emblem in the center so I can add my own. I have looked all over and cannot find the wings. I want something to match my startech. I appreciate the help!

1

[todd0218]

yes the chrysler emblem will come off. remove the glue in the i think two holes behind the emblem apply a decent amount of heat from heat gun as well as pushing screwdriver into holes in back to pop emblem off. enough heat will make the glue soften and allow the emblem to come off.

[cheifsfan]

Thanks,

Where can I buy the wings without an emblem in the middle?

Thanks!
Pat

[todd0218]

Originally Posted by cheifsfan

Thanks,

Where can I buy the wings without an emblem in the middle?

Thanks!
Pat

our supporting vendors wyckoff or mopar super center

[joey]

I havn't seen a wing sold without an emblem.
But you can remove the emblem.

Someone recently posted some pics on how to remove the emblem, but I can't find the thread.
They drilled a small hole in the emblem, then drilled a screw into the hole until the emblem was ready to crack. I think they then pulled on the screw until the emblem popped out, but I could be wrong. I think they also used more than one screw.
I believe they posted this pic after the emblem was removed.

[stealthsrt8]

if you order the wings, they come with an emblem. it's easy to pop out the emblem when the wing is not attached. you can put a small screwdriver or awl through the holes in the wing and push the emblem out.

if your wing is attached, follow the procedure i wrote:

How to: Replace Emblem in 300 Wing

[joey]

Originally Posted by stealthsrt8

if you order the wings, they come with an emblem. it's easy to pop out the emblem when the wing is not attached. you can put a small screwdriver or awl through the holes in the wing and push the emblem out.

if your wing is attached, follow the procedure i wrote:

How to: Replace Emblem in 300 Wing

That is the thread

[cheifsfan]

Thanks! I need to do this asap!

Thanks again!
Pat