Disable seat belt chime (Threads Merged)

[stunna55]

does anyone know how i can make that annoyig as hell seat belt noise go off. i know i should wear my seat belt and i do 90% of the tme but when your like driving on the beach u really dont wanna wear it and its really annoying. if anyone could help by telling me a wire to cut or a fuse it would be very helpful. thank you. the passenger air bag beep is really annoying also.

[MGD]

Just get an old seat belt lock from the junkyard that fill fit and your worries are gone.....but not legal.

[HEMEEE]

Hey stunna55, as a nurse the best advice I can give you is simple... Fasten your seat belt and the alarm will disappear!! The small percentage of time that you may spend driving on the beach does not warrant disabling this safety feature for the majority of your driving experience. There are too many people out there that will never be able to drive again for failure to fasten their belt. Not to mention warranty and resale issues.

Please DON'T!

[Bobs05RT]

Look in the owners manual. It tells you how to silence that annoying chime.

[II kings 9:20]

Wear the belt 100%, "you never see the missle that kills you".

[joey]

As Bob said, the manual explains how to silence the chime.
I just can't recall how.
However, you cannot get rid of the red light on the dash.

[CottyGee]

Wear your seatbelt 100% of the time. Or don't - and increase the liklihood that you are eliminated from the genepool...

[340HP]

Are you crazy? You should wear it 100% of the time!

[jamoleh]

While I was reading the manual my eyes cought this:

Note:
The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON or START position. DaimlerChrysler does not recommend deactivating the Enhanced Warning System (Belt Alert).
1.Turn the ignition switch to the LOCK position and buckle the driver's seat belt.
2.Start the engine & wait for the Seat Belt Warning Light to turn off.
3.Within 60 seconds of starting the vehicle, unbuckle & then re-buckle the driver's belt at least three times within 10 seconds, ending with the seat belt buckled.

Note:
Watch for the Seat Belt Warning Light to turn on while unbuckling and off while re-buckling the seat belt. It may be necessary to retract the seat belt.
4. Turn off the engine. A single chime will sound to signify that you have successfully completed the programming.

The Enhanced Warning System (Belt Alert) can be reactivated by repeating this procedure.

Note:
Although the Enhanced Warning System (Belt Alert) has been deactivated, the Seat Belt Warning Light will continue to illuminate while the driver's seat belt remains unbuckled.

Disclamer:-
This is as per the manual & I shall not hold any responsiblities as to what will be the consequences of this post & I shall not be held responsible coz I am known as the Mad Man who drives 250 Km/h with out a seat belt.(By the way I cannot be sued coz I am not in the U.S. LOL )

[300PMP]

So annoying...It's helped me to be more safe about wearing it, but is there any way to disable that alarm?