Stock 300C Dyno!!!

Shmirgin44 · 02-26-2005, 04:06 PM

I'm pretty impressed considering DCX rated the car @ 345HP @ the crank!

steve 300c · 02-26-2005, 04:10 PM

Impressive, That's a great Baseline for us to work off!

Shmirgin44 · 02-26-2005, 04:17 PM

anybody else dyno one yet? I wanna see how my #'s compare...

**aspendog** · 02-26-2005, 04:24 PM

[quote=Shmirgin44]I'm pretty impressed considering DCX rated the car @ 345HP @ the crank![quote]

Do you know if those # are corrected?

Shmirgin44 · 02-26-2005, 04:32 PM

yessir, they are!

300C_AWD · 02-26-2005, 06:03 PM

That dyno run is really odd. The run seems to stop at 4750 when it's clear the engine would of graphed higher HP's at higher RPM's. Are those 1 to 3rd gear peaks? If so why the low load and if so then 3rd is too steep and looks erroneous. I see a 2 point plot on the segment from 4500 to 4750. Also my auto shift points are almost redline on my AWD not near that low. Maybe I'm reading this wrong but the PEAK on this dyno run does not look valid to me. Please explain how the dyno was run?

Shmirgin44 · 02-26-2005, 06:06 PM

They used the autostick to put it in 4th gear and then hammeres it from about 1700 rpm's on...any irregularities were caused by the car's computers not being happy with being tricked (had to pull the ABS fues to even get it to run at al on the dyno)...that's all I can say...

Gloveperson · 02-26-2005, 06:16 PM

That is an odd dyno..good numbers though! And is that a mustang dyno i see?!?

Wish it didn't stop going...it doesn't even go to 5252 to see if it was done correctly

Shmirgin44 · 02-26-2005, 07:04 PM

well if anyone can offer me any tips on how to better "convince" the PCM to cooperate...I'm all ears!

MrHappy · 02-26-2005, 08:26 PM

I'm just curious to know how it was done March 14th of 05?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Remove Advertisements Sponsored Links
Chrysler 300C & SRT8 Forum Advertisement