3rd brake light?

[300onBags]

How do you get to the 3rd brake light? The part thats right behind the back windsheild?

[joey]

Found these instructions in the Service Manual.
Doesn't look too easy.


You have to first remove the upper and lower C-Pillar Trim.
Then remove the rear panel
Then the 3rd brake light.

[CUEBALL]

Actually takes about 5 minutes. Remove the bolts on the side bolsters, use a flat blade screwdriver to pry down on the clip holding the bolsters in and pull forward. Once the bolsters are out, take the side trim piece out (screwed in) then pull forward on the center of the cargo shelf cover and it will come out (one plastic anchor in the middle..). Then two small screws and the brake light is free. I'll look for a link and post it here on the side bolster removal.

http://www.300cforums.com/forums/int...ake-light.html

How To: Remove Rear Deck Cover & Rear Speakers

[digitalfreeze]

atta boy cueball!

[leodogg24]

speaking about the light, does anyone make a cutout cover that goes in the center of the light to make something like a saying of 300c,or srt8? i had a older fiero while back and got one for it. when you put the brake on it said fiero,or fiero gt. and looked pretty cool. it was made out of a piece of brushed alumiunm. i seen people use vinyl,but this way looked alot better.

[CUEBALL]

Originally Posted by leodogg24

speaking about the light, does anyone make a cutout cover that goes in the center of the light to make something like a saying of 300c,or srt8? i had a older fiero while back and got one for it. when you put the brake on it said fiero,or fiero gt. and looked pretty cool. it was made out of a piece of brushed alumiunm. i seen people use vinyl,but this way looked alot better.

Check google. I don't think I've seen it here on the forum, except in questions like yours.

[CUEBALL]

Originally Posted by digitalfreeze

atta boy cueball!

Thanks. But I have to credit Notyet with the honor of clarifying those instructions for me one day a few months ago. But those links are even more in depth than some of the ones I was referencing. Pretty easy task once you figure out what you have to do.

[Lik2race]

Originally Posted by leodogg24

speaking about the light, does anyone make a cutout cover that goes in the center of the light to make something like a saying of 300c,or srt8? i had a older fiero while back and got one for it. when you put the brake on it said fiero,or fiero gt. and looked pretty cool. it was made out of a piece of brushed alumiunm. i seen people use vinyl,but this way looked alot better.

Go here >>>
eBay Motors: Chrysler 300 300c 3rd Brake Light Cover 05 06 07 (item 320141795136 end time Aug-03-07 0531 PDT)

Even though this auction is over, contact the Seller, he will make any kind you want.
Stan

[300onBags]

Originally Posted by Lik2race

Go here >>>
eBay Motors: Chrysler 300 300c 3rd Brake Light Cover 05 06 07 (item 320141795136 end time Aug-03-07 0531 PDT)

Even though this auction is over, contact the Seller, he will make any kind you want.
Stan

yup he is right...I got mine to say GOTBAGS

just like my headrests and vanity plate..Thats why I started this thread!! Thanx guys

[300onBags]

Only took me about an hour. Would have been done quicker but I had to search for tools..LOL!! How does this look?