Quad Brake Lights For The 300c

[Mr. iNCREDIBLE]

I did this 2 1/2 years ago.. only I didn't cut anything I used the stock wiring as the connections are already there.

the bottom lights in Europe are the rear fog lights..

I put LED strobing lights in my lowers so they wig-wag flash 3 times then go solid..... extra caution/alert

[prican_2000]

Originally Posted by Mr. iNCREDIBLE

I did this 2 1/2 years ago.. only I didn't cut anything I used the stock wiring as the connections are already there.

the bottom lights in Europe are the rear fog lights..

I put LED strobing lights in my lowers so they wig-wag flash 3 times then go solid..... extra caution/alert

Mr. I can you please explain how it was that you did this mod without cutting anything?????

[Mr. iNCREDIBLE]

there is a rubber water seal grommet on the bottom of the plug.. pull it out and run a wire thru it on the 3rd side that is empty, solder the wire to the clip that is on the inside of the connector..

run the wire to the top light and remove the rubber grommet there, solder the bottom light wire to the top light brake wire (run the wire through the hole where the brake wire is, tight fit but can be done)

reinsert the rubber grommet into the connector base.. that's it.. took about 10 minutes for each side..

[prican_2000]

SCHMOOOOOKIN!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Thanks Mr.I !!!!!!!!!!!!!!!!

You come through yet once AGAIN.