3.5L motor mods

[GROUNDED]

I havent seen a sticky list yet so I figure why not start one that someday may be a sticky.

3.5L performance


B&G PCM Flash - $450
05/06 3.5L V-6 “300/Charger/Magnum” Premium fuel & (MBT) timing curves, 7000 rev limit, cooler fan on temp, 140 mph limit, modified torque management

BORLA EXHAUST -Part # 140127 MSRP $953.99

JET PERFORMANCE CHIP - STAGE 1 AND 2 Part's #90405 / 90405 s

COLD AIR INTAKE - DUB, K&N,....



Here is a start, lets add some more.

[xTACKLEBERRYx]

DUB doesn't make a CAI for the 3.5L right? I've been looking at the K&N AirCharger but I've heard there isn't much of an audible difference from the stock.

As for the exhaust I would recommend the Magnaflow dual exhaust instead of the Borla. I love the sound of it and the look of the dual tips sticking out in the rear.

[GROUNDED]

Originally Posted by xTACKLEBERRYx

DUB doesn't make a CAI for the 3.5L right? I've been looking at the K&N AirCharger but I've heard there isn't much of an audible difference from the stock.

As for the exhaust I would recommend the Magnaflow dual exhaust instead of the Borla. I love the sound of it and the look of the dual tips sticking out in the rear.

i know on mine it seems like the motor is REALLY starved for air so im most likely going to install a k&n cai or make one when i get a chance, As far as the exhaust goes i would like to do a true dual w/ x pipes and mabey an aero turbine muffler setup. i know that the magnaflow and borla are way overpriced and i can get the ss tubing and muffler and fully tig weld my exhaust if i choose to. i will also probably do dual tips on either end. Does anyone know of any where i can hear some exhaust clips of different setups on the 3.5 magnum, 300,....

[XxNoVaxX]

I got this cheap one from ebay and i can tell a difference... Looks good too...

[xTACKLEBERRYx]

Has anyone seen or heard anything about this exhaust system? Chrysler 300 / Dodge Magnum Charger Mopar Performance Exhaust It's the Mopar Performance Exhaust for the 3.5L. It's made by Borla for Mopar but Borla doesn't make a dual exhaust for the 3.5L according to there site. Not to mention that price just is way to low for a Borla dual exhaust.

Does anyone know why Mopar doesn't make a 3.5L CAI. They make it for most of their other engines. Is there something in the works for the future?

[str8maxn]

Has anyone added a B&G reprogram to here 3.5?
Any difference?

Has anyone used a magna flow single exhuast upgrade?