Auto-up power window not working on driver's side

[DZeckhausen]

Recently, I noticed that my driver's window no longer goes up in 1-touch mode. You must hold the power window switch up until the window is fully closed. The passenger side window still works properly from either switch.

My driver's side window still goes all the way down with a single touch. It just won't come all the way up any more.

Has this happened to anyone else?

[C-Man]

Try recalibrating it with the following:

AUTO UP FRONT WINDOW
If the vehicle is equipped with the auto-up front window feature, once the battery is reconnected the door module
needs to be calibrated. The door module requires calibration anytime the battery or door module has been disconnected
for any length of time. To calibrate, perform the following:
1. Connect the battery cables.
2. Using the window switch, raise the window to the full UP position. Hold the switch in position for 1 second, then
drive the window all the way down to the bottom.

[DZeckhausen]

Originally Posted by C-Man

Try recalibrating it with the following:

AUTO UP FRONT WINDOW
If the vehicle is equipped with the auto-up front window feature, once the battery is reconnected the door module
needs to be calibrated. The door module requires calibration anytime the battery or door module has been disconnected
for any length of time. To calibrate, perform the following:
1. Connect the battery cables.
2. Using the window switch, raise the window to the full UP position. Hold the switch in position for 1 second, then
drive the window all the way down to the bottom.

That worked. Thanks!

[Tha187um]

DZ, this happens not only when you disconnect the battery, Im sure you didn't do that since both your windows would have gotten messed up... if you unplug the module from the door panel would cause this as well...

[DZeckhausen]

Originally Posted by Tha187um

DZ, this happens not only when you disconnect the battery, Im sure you didn't do that since both your windows would have gotten messed up... if you unplug the module from the door panel would cause this as well...

Actually, I did disconnect the battery when I installed my Bluetooth (UConnect) retrofit kit. And only the driver's side window got messed up. That's odd.

[Gary Freedman]

This happened to my 300C when it was two weeks old. The battery nor the door module was never disconnected. However, after two days, the driver's door window started working again, and has continued to do so.

My 300 has soooo many electical problems, that the top Chrysler Tech guys are involved now.

I also had to disable the rain sensing wipers. They went into slow speed in a hard driving rain, while I was driving 60 mph!! I switched the wipers to the regular intermittent program. Now at times, while they are in the 2nd or 3rd intermittent position, they go into low speed!! My dealer is simply scratching their heads at the problems associated with my vehicle.

[dnar]

My drivers window has been doing this for weeks! It of course started working yesterday, knowing full well it was going to the dealers today...

The strange thing is, in the 3 or 4 weeks it was faulting, some days it would work and the front passengers window would not auto up. Very odd.

[CSJBOAT]

For some reason, every now and then my driver side window auto up stops working. I have to recalibrate it about every two or three weeks!

[DZeckhausen]

Originally Posted by CSJBOAT

For some reason, every now and then my driver side window auto up stops working. I have to recalibrate it about every two or three weeks!

This happens to my SRT8 as well. (When I started this thread, I had an "ordinary" 5.7 liter 300C.)

[terrysrt8]

I noticed that if you attempt to raise your window without pulling up all the way, to close the window partially, this disables the auto feature. So the next time your raise the window all the way, you have to release the switch (once it is fully closed) and then pull switch up again (this recal's the auto feature).