Lowered....read this and support it you must!!!!

[300C2NV]

Originally Posted by UniversalAirSuspension

oops sorry i missed the last question. You can run 35 series its just when you drop it the tires hit the inner plastic liners. with 30 series they dont. It wont hurt anything though.

So when you have 30 series, you can actually drive the car while it's layed out?

[DUBSTER]

Originally Posted by 300C2NV

So when you have 30 series, you can actually drive the car while it's layed out?

It depends on the offset and size wheels you have. I have 22x9.5 wheels and i can't do that. Too wide, did you have a hot wheel car and tuck the wheels right up. LOL!! I can't roll!!

[300C2NV]

Heh, I just want to be able to roll in a straight line while i'm dropped, maybe not all the way down, just pretty low. Can you basically stop lowering at any heighth, or can you drop and raise only to preset levels and heights?

[DUBSTER]

Originally Posted by 300C2NV

Heh, I just want to be able to roll in a straight line while i'm dropped, maybe not all the way down, just pretty low. Can you basically stop lowering at any heighth, or can you drop and raise only to preset levels and heights?

They do not recommend to do that, may damage bags. I don't have any preset levels. The longer you hold the center switch the faster it will go up or down. I bring mine up and down slowly. I don't like playing with it, just me I guess!! Remember the controller I posted, there are 9 buttons. Top 3:LF wheel, both front wheels, RF wheel. 3 buttons going down: Top L both wheels, center whole car, bottom R both wheels. Bottom 3 buttons: LR wheel, rear both wheels, RR wheel. Here is the pic of the controller.

[300C2NV]

Phew, I'm SOOO ready for my UAS system. Zack, do you know of any install shops in Arkansas? There's like, NOTHING in Arkansas, and the only shop I can think of (Motorsports Authority) I think everyone there quit or something.

[KillerC]

Originally Posted by 300C2NV

Phew, I'm SOOO ready for my UAS system. Zack, do you know of any install shops in Arkansas? There's like, NOTHING in Arkansas, and the only shop I can think of (Motorsports Authority) I think everyone there quit or something.

300C2NV

You should really check out my setup sometime. I think you would really like the digital gauges better. I will be in Canada next week, but when I get back and if you do want to meet up one afternoon just let me know. Are u going to the Arkansas Super Car Show on Aug 6th? I am going to try to make it back by then but not sure yet???

Dubster

Do you have a remote that controls your setup?

[UniversalAirSuspension]

Originally Posted by 300C2NV

So when you have 30 series, you can actually drive the car while it's layed out?

On mine i have 22x9.5 with a 255x30x22 nitto tires. I can roll the care completely layed out however if there is any humps in the road the car will drag the ground.

Dubster is correct driving the car layed out will damage the bags along with the car in general

[UniversalAirSuspension]

Originally Posted by 300C2NV

Heh, I just want to be able to roll in a straight line while i'm dropped, maybe not all the way down, just pretty low. Can you basically stop lowering at any heighth, or can you drop and raise only to preset levels and heights?

Dakota Digital makes a unit that uses height sensors like the benz to have a "low, med, hi" height.

With the way the setup is, when you hold the pancake up switch it will lift the whole car up to a good ride height. And then when you tap it down, its usually about an inch lower per tap.

[KillerC]

Originally Posted by UniversalAirSuspension

Dakota Digital makes a unit that uses height sensors like the benz to have a "low, med, hi" height.

With the way the setup is, when you hold the pancake up switch it will lift the whole car up to a good ride height. And then when you tap it down, its usually about an inch lower per tap.

This is the setup I have. ITS AWESOME!!!

[300C2NV]

Originally Posted by KillerC

This is the setup I have. ITS AWESOME!!!

KillerC. I'm VERY interested in getting together with you one day to check out your ride. My car is down right now becuase my tail lights are gone to get tinted and won't be back untill at LEAST next friday. Also, my center console lid is gone to get wrapped in leather via 22Elite. I'd be more than happy to come check out your ride one day. I have to work Mon-Wed every week, but other than that, I should be good to go. I might have to detail a car or two in between there, but it should still work. Just let me know when your getting back into town, cuase I definately wanna see yours before I take the plunge! I'll be at that car show also. Thanks man!