Air suspention on the way - Page 2

GROUNDED · 03-05-2008, 06:35 AM

Appears to be UAS

Dove dkla · 03-05-2008, 09:09 PM

thanks grounded

BAG-63D · 03-06-2008, 04:29 AM

Dont look like UAS to me.

Looks like EasyStreet rear setup

GROUNDED · 03-06-2008, 07:05 AM

Yea, I was gonna correct myself on that once I noticed the rear cups, but Im sick and I was too tired to do so last night.

Crazy1 · 03-13-2008, 09:58 AM

Ha I finally fisnish it on thuesday. It took my two week becose of the danm show. I live in Laval it's in Quebec and we had a huge snowstorm. I'll try to send picture this week. Yes it is Easystreet setup.

benro$$ · 03-13-2008, 12:27 PM

looks good. i got caught in that snow storm right when I drove into Montreal Saturday night. Worst night ever, the 300c didnt fair too well in all of that snow and I lost my phone in the what seemed like 2 feet of snow that fell. Anyways, very nice setup.

jeffroe334 · 03-13-2008, 03:19 PM

I'm confused.. The air hoses to the bags were ran through the inside of the car???

I thought you normally would bore holes in the rear spare area and run them underneath? Did you do this because of the cold?

I just never seen it done that way, again I'm in South FL where it doens't get cold.

-Jeff

Simans82 · 03-13-2008, 05:16 PM

Quote:

Originally Posted by jeffroe334

I'm confused.. The air hoses to the bags were ran through the inside of the car???

I thought you normally would bore holes in the rear spare area and run them underneath? Did you do this because of the cold?

I just never seen it done that way, again I'm in South FL where it doens't get cold.

-Jeff

I would say that it's completely up to the discretion of the installer. I've never seen on done the same (unless it came out of the same shop).

Crazy1 · 03-13-2008, 07:31 PM

No it did not come from the shop like that. I did all the work myself. The hose ran from each side of the inside of the car under the carpet as for the rear I did 2 hole not inside or the spare wheel but on top of the diff. and it goes on each wheel after. I mont everything on the diamond plate so I can thake it of if I have to. Here a cople of pic hope it help

Here is where I start

Here is what it look like when I finish

This is what it look from under

Now you can see the hole for the back

Now all the hose are there whit the ground and the juice

GROUNDED · 03-13-2008, 08:51 PM

Keep an eye on those plastic fittings. Ive had problems with them leaking in the past.