Chrysler 300C & SRT8 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. General Discussion
    Hello all, someone I know is selling an 08 Chrysler 300 5.7 AWD with a bad transmission. I have previously owned and worked on an 07 charger 5.7, so I'm fairly familiar and competent with the mechanical work that goes with them. My question is: is the nag1 in the 5.7 AWD the same/interchangeable...
  2. General Discussion
    I did a pretty significant tear down of the top end of my 07 3.5L AWD. The intake, especially the short runner butterfly valves were severely gummed up I thoroughly cleaned the inside of the intake, especially the shaft between the ports, using carburetor cleaner and simple green, as well as a...
  3. General Discussion
    After spending 3 hours removing my wife's starter due to way too short cables I made my own with a 2 gauge main and 14 gauge solenoid cable to hook into the factory wires so it takes 20 minutes next time.
  4. General Discussion
    I removed the starter from my wife's 07 W.P. Chrysler Signature Edition AWD, took me 20 minutes to remove the heat shields, steering rod and drop the rack Then 3 hours to remove the nut holding the battery cable to the solenoid, there was no way to get a socket on it with or without extensions...
  5. General Discussion
    What is the most efficient way to remove an 07 3.5L starter, just from looking at it, it looks like remove the air intake tube possibly filter box, remove motor mount heat shield, remove motor mount and get it out. I looked at the Haynes manual instructions and it said something about...
1-5 of 5 Results