I have a 2006 Chrysler 300 V6 3.5L. I replaced the EGR valve and the spark plugs. I then drove it and the lightning bolt came on after 10mins or so driving. Turned the car off then back on and lightning bolt was gone. Started driving again and a few mins later lightning bolt came back on. Put a...

Hi I have a 300C with a 5.7 hemi and I've been having some problems with the engine. Problem: When I accelerate the car responds with a harsh jerking movement, almost as if the power is cutting in and out. It only does this when I give it a good amount of gas other than that I have to...

Ok I have to get a new EGR Valve... I got the code that has my engine light coming on and off... I found the EGR at Napa, Autozone, and Advanced Auto parts for $45 dollars but the dealer wants $137 for the EGR valve... I like saving money but I also believe you get what you pay for... Should I...

Hi, My name is Ajay and I am a new member on this forum. I’m from The Netherlands, Zoetermeer. I’ve recently bought a 300C CRD. 11-2005 model with 122.000km (75.000 mil) Car is driving fantastic and I love it.:yeah: Now I am thinking about chip tuning the car and got the following information...

Hi, I'm a new member and would like to know what would be the easiest way of replacing the upper EGR tube seal (blue rubber seal). This seal is between the upper manifold the upper EGR tube. I have a vacuum leak from a recent tuneup job in which the techs failed to seat the seal properly...

After replacing the EGR valve on a 2005 300C and disconnecting the negative terminal for 5 minutes, the car started, ran rough for 2-3 seconds then stalled. Restarted 3 times with same result, then nothing. I disconnected the battery again, but still nothing happens when I turn the key. I no...