Chrysler 300C & SRT8 Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. 1st Gen SRT8-Specific Problems/Dealer Service
    Hey guys I'm at a loss. Took my 09 300c 5spd in to local mechanic to find issue with limp mode. ABS ESP BAS lights were illuminated and vehicle was stuck in limp mode. Long story short, it was the reluctor rings on the cv axle half shaft that were bad. Changed cv axles then the code cleared. I...
  2. 1st Gen SRT8-Specific Problems/Dealer Service
    I have a 2006 300c srt8 6.1 hemi model. Car was running fine for a year. Replaced the back 2 tires and then check tpm on dash came on car still running fine for about 6 months. Then all the sudden check gas cap came on so bought a new gas cap. Dash still says check gas cap and now my check...
  3. General Discussion
    What sensors can go bad that will send a car into limp mode? I have a 2005 300C 5.7L - 94k - It will run for an hour then into limp mode Codes The TB has been replaced P2101 Electronic Throttle Control Motor Performance P2118 Electronic Throttle Control Motor Current Performance - Bank 1...
  4. General Discussion on Issues / Trouble Shooting
    So this has been a long-time issue - 2005 300C 5.7L 94k The first instance happened as I was driving a back road, was at a stop, stepped on the pedal: limp mode red lightning bolt and the ESP BAS lights lit up - Turned off the car, restarted, worked for 10 mins, repeat The car starts up - drive...
  5. General Discussion
    Hey guys, my 2005 Chrysler 300c hemi has 198,000 miles on it with a new engine put in at 196,000 miles. It is having this problem where it will stumble and trip up as If i accelerate too fast. If I accelerate a little bit, wait and let the car speed up and shift gears, then I can accelerate a...
  6. General Discussion on Issues / Trouble Shooting
    Hi, I have seen some similar issues but not quite what I'm dealing with. The extra challenge for me is that I live in Malta, a small mediterrrenean island where you can't find qualified mechanics and it's all botched work. I usually take the ferry and drive to Austria to fix it, but that's not...
  7. Problems / Dealer Service
    I have a Chrysler 300c 2005 , car keeps going into limp mode , sometimes will rev up and not move , went to do a tranny flush made it worst , goes into limp mode every time , so I tried to decide to drive it on manual mode , still same thing goes into limp mode , car will jerk at 40kms an hour ...
  8. General Discussion on Issues / Trouble Shooting
    Hi I have a 300C with a 5.7 hemi and I've been having some problems with the engine. Problem: When I accelerate the car responds with a harsh jerking movement, almost as if the power is cutting in and out. It only does this when I give it a good amount of gas other than that I have to...
1-8 of 8 Results
Top