Chrysler 300C & SRT8 Forums banner

transmission problems

  1. 2006 300c SRT8 Torque Converter Problem

    1st Gen SRT8-Specific General Discussion
    Good day all, You may have seen some of my other posts on this form about my 06 SRT8 and the journey I've gone through fixing this thing up. One of the issues that has been around since the beginning is an odd fluctuation in the RPM when under light load (driving up hill at low RPM). The...
  2. Problem with my 300C 5,7, and I am totally lost.

    General Discussion
    Hi there, This is my first post,and if anything is mispelled, it's because I am from Denmark. I have recently bought a Chrysler 300C 5,7 from 2010. Now it has started acting up! As you can hear in the video listed below, the car wont accelerate proberbly. It's going up and down in refs, and...
  3. Losing speed quickly when coasting, rough/late shifts, PCM?

    General Discussion on Issues / Trouble Shooting
    Hey guys, first time posting here I’ve been on here reading frequently since I got my car back in August. Cut to the point, there seems to be an issue relating to the transmission. I first noticed it when my car stopped being able to coast. I release the gas at speed, and it immediately starts...
  4. 2006 300C constantly having trouble upshifting

    General Discussion on Issues / Trouble Shooting
    Hello! I am an ecstatic new owner of an '06 300C, I love it, but starting the first week everyday I encounter the RPMs going through the roof and unable to upshift into third gear. When this happens I let off the accelerator and instead of coasting the car almost comes to a complete stop like...
  5. 2012 300C (Issues with engine and Trans?)

    General Discussion
    Hi all, Before posting this new thread, I went and checked around however most if not all similar posts are related to older models. A bit about the car. It is a V8 bought used with 25k km. still under warranty and have a gold plan. Now it have 53k km. In short I have 3 concerns that I face...
  6. Installed 3.55 gear, rebuilt tranny and converter.problem

    General Discussion on Issues / Trouble Shooting
    Hey guys I'm new to the forums I have a 2005 chrysler 300c tranny went. I have gotten a built tranny to hold more hp and a 2800 stall converter with 3.55 just installed and the care goes into a limp mode and doesn't like going first gear drive after you stop once your going a bit. Does anyone...
Top