Chrysler 300C & SRT8 Forums banner
1 - 11 of 11 Posts

· Registered
Joined
·
236 Posts
Discussion Starter · #1 ·
Hey guys, finally got some tires and rims that will grip all this power, keep in mind I am nowhere near stock, nearly 600 RWHP, low 11's in the 1/4 mile and needed the extra sidewall and sticky tire, I only run these at the track so looks are not what I'm going for, was very hard to find a 17x10 inch rim that would fit without having to remove the sway bar. Would have been fine with pretty much any 18" rim but needed the tire to go with it, these are 295-45-17 Mickey Thompson ET Street Slicks and man do they grip, seriously improved my time in my 60 ft and 1/4 mile. View attachment 62961
View attachment 62969
View attachment 62977
View attachment 62985



Sent from AutoGuide.com Free App
 

· Premium Member
Joined
·
6,064 Posts
Your attachments aren't working for some reason. BTW, what have you done to your car to get that kind of HP and low 11's? That is very fast.
I think he is spraying Jim... :)
 

· Registered
Joined
·
236 Posts
Discussion Starter · #6 ·

· Registered
Joined
·
236 Posts
Discussion Starter · #8 ·
Your attachments aren't working for some reason. BTW, what have you done to your car to get that kind of HP and low 11's? That is very fast.
Did the basic mod setup, headers, high flow cats, exhaust, ported throttle body, LMI true cold air intake, and of course the most important, a hell of a dyno tune, but what really have me the boost was nitrous, figured, spend a 1000 on a good kit and be faster than a supercharged srt8, it's a no brainer, I'm at least a half second faster than a supercharged srt8 and it cost me 7500 less!! Plus I got an automatic bottle opener which means that if some one pulls up to me on the highway I can open the bottle with the flick of the switch and blow their doors off, I have it set to my throttle body so when activated all I do is hit the gas and it shoots.
 

· Registered
Joined
·
236 Posts
Discussion Starter · #10 ·
The rims are actually truck rims with a negative -25 offset, think these were made for an older jeep, bolt pattern on rims were 5x114.3 our cars are 5x115 although they fit it's not good to run different bolt patterns no matter how small a difference so I had them machined and inserted to be 5x115, it cost me $25 per wheel but well worth it, I put them on before I had them machined and I twisted 2 studs that I had to replace at $20 each so if your gonna hit the track make sure it's the correct bolt pattern


Sent from AutoGuide.com Free App
 

· Registered
Joined
·
236 Posts
Discussion Starter · #11 ·
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top