Chrysler 300C & SRT8 Forums banner
1 - 11 of 11 Posts

· Registered
Joined
·
136 Posts
Discussion Starter · #1 ·
Here is my demo I did up. Wheels are by Veloche "Villano" 22 inch. Tires are Pirelli scorpion zero 265-35 zr22 102w. Window tint is 50% and the grill is a E&G classic stainless steel. Enjoy!! I sure do!!
 

Attachments

· Registered
Joined
·
922 Posts
redwinger,
Breath taking! Nice job yeah I was thinking about 50% tint so all can get a tiny glance of driver.:p
 

· Premium Member
Joined
·
2,650 Posts
I know tire sizes are limited but that tire seams to stick out too far! If that car was lowered that 265 would not work. I think the use of those 265's up front will be a pain in the long run, especially because of the stuff it will kick up on the sides. My Ol Lady is worrying me about putting the splash guards on the OEM 225 width tire because this car kicks up to much debris.

 

· Registered
Joined
·
152 Posts
Looks great! I know your joy. And a fellow Minnesotain. My grill comes in next week. I didn't go 50% on the tint, I got a ticket on my last car at 50%.
 

· Registered
Joined
·
152 Posts
I went one under legal, to be honest I don't know what the percentage was. On my last car I went 2 under legal and got busted (while speeding and he thru the tint ticket in for fun).
 

· Registered
Joined
·
136 Posts
Discussion Starter · #9 ·
In Minnesota 50% is the legal max. No we do not do the Trunk monkey ads. Great commercials though. The dealer that does it is a dealer in Oregon if I am not mistaken. We the dealership paid for the acc. Unfortunately I only get to demo it for a week and it will be sold. We have been customizing these with wheels and grills, tint rear seat headrest monitors etc. Have found that as soon as they are done up they sell right away. As far as them kicking up to much debris it has not been a issue at all. I do see your point though.
 

· Registered
Joined
·
441 Posts
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top