Chrysler 300C & SRT8 Forums banner
1 - 8 of 8 Posts

· Registered
Joined
·
888 Posts
Discussion Starter · #1 ·
I have a Volant and Borla 4 muffler system. Just removed the 2 rear mufflers (to make the system a 2 muffler like Borla's 140125, only with the 3.5 tips).
Removing the 2 rear muffler's on the Borla setup sounds great - it's finally what I thought it should be....BUT

Now have a check engine light (not flashing).

last warning chime was MIL LAMP VMM 319

?? Any ideas ??
 

· Administrator
Joined
·
7,148 Posts
5.7 I had a CEL just after installing my Volant CAI. The computers corrected themselves after several days of short driving jaunts. I suspect yours will recycle itself as well.

Good Luck! :)
 

· Registered
Joined
·
888 Posts
Discussion Starter · #4 · (Edited)
Just checked the code:
P0520 Engine Oil Pressure Sensor/Switch Circuit Malfunction

....things that make you go hmmmmmm.......

***ON EDIT - Code reset after I checked it, no more CEL.
 

· Registered
Joined
·
963 Posts
Just checked the code:
P0520 Engine Oil Pressure Sensor/Switch Circuit Malfunction

....things that make you go hmmmmmm.......

***ON EDIT - Code reset after I checked it, no more CEL.
how did u reset this code?
 

· Registered
Joined
·
16 Posts
Just checked the code:
P0520 Engine Oil Pressure Sensor/Switch Circuit Malfunction

....things that make you go hmmmmmm.......

***ON EDIT - Code reset after I checked it, no more CEL.
I just got the same trouble this morning. No mods done to my car besides lowering. Any suggestions? I got a new oil pressure sensor switch from autozone today. Is it hard to swap out?
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top