Chrysler 300C & SRT8 Forums banner

1 - 2 of 2 Posts

·
Banned
Joined
·
1,300 Posts
Discussion Starter · #1 ·
I'm sure the info is scattered about here somewhere, but can someone collect this in one response?

What are the following STOCK diameters on the SRT-8?

1) Header tubes
2) Header Collecter
3) Cat inlet/outlet
4) Cat
5) Pipe from cat to resonator
6) Resonator inlet/outlet
7) Pipe from resonator to mufflers
8) Muffler inlet/outlet

Finally, has anyone installed a full system INCLUDING long tube headers?
 

·
Registered
Joined
·
482 Posts
JMatt said:
I'm sure the info is scattered about here somewhere, but can someone collect this in one response?

What are the following STOCK diameters on the SRT-8?

1) Header tubes
2) Header Collecter
3) Cat inlet/outlet
4) Cat
5) Pipe from cat to resonator
6) Resonator inlet/outlet
7) Pipe from resonator to mufflers
8) Muffler inlet/outlet

Finally, has anyone installed a full system INCLUDING long tube headers?
1. I don't know
2. I don't know
3. Cat inlet is large, comes out at 2.75"
4. Not sure of the body size
5. Pipe is 2.75" to mid body muffler
6. 2.5" inlet and outlet ports. Necked up to 3" immediately on outlet
7. 3" pipe
8. 2.5" inlet on muffler. I believe the exit is the same, but I forgot. I'll craw into the attic to look at it again.

Here is a link to the post.
http://www.300cforums.com/forums/showthread.php?t=8210
 
1 - 2 of 2 Posts
Top