ghbbuzzard...
did you do it yet?
if you are jacking the fronts...
look at my post in the exterior upgrades section on Hoen Fog Lights upgrade....
I kinda of went into detail on it...
I have a ton of pictures...
but can't get them past my filter at work...
get on the ground...
look from behind the wheel while you lay about where the front door hinges...
you'll see a silver heat shield about 2-3 inches wide and 4-6 inches long...
the jack point for the cross member section is right there...
it is tight...
I was just able to get my small jack under it...
once you get it lifted turn the wheels so you can get access to the front valence...
there is some other posts about the screws and stuff that might help as well...
good luck!!!
did you do it yet?
if you are jacking the fronts...
look at my post in the exterior upgrades section on Hoen Fog Lights upgrade....
I kinda of went into detail on it...
I have a ton of pictures...
but can't get them past my filter at work...
get on the ground...
look from behind the wheel while you lay about where the front door hinges...
you'll see a silver heat shield about 2-3 inches wide and 4-6 inches long...
the jack point for the cross member section is right there...
it is tight...
I was just able to get my small jack under it...
once you get it lifted turn the wheels so you can get access to the front valence...
there is some other posts about the screws and stuff that might help as well...
good luck!!!
