Chrysler 300C & SRT8 Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'm brand new, so bare with me if i'm in the wrong topic :)

I recently bought a 2005 Chrysler 300c in Sweden.

it had a knocking sound from the front, so i replaced tie rod, outer bearings etc. and had it alligned.
Everything runs smooth now.

After some time i noticed a strange behaviour when doing hard brakes or reversing while turning (Sharp/tight).
When driving forward Again the steering was a little off center to the right.
But the car still runs perfectly straight.?

a hard Jack to the left, and the steering Wheel is centered Again. Still driving dead-straight.

So i figured it might be bushings on the steering rack. So i replaced those as well.

but the problem remains, but i have narrowed it Down to being triggered by hard braking.

I have spoken to few mecanics and they look just like big question marks..
i have refitted everything. All bolts are dead-tight etc.

ANY idea would be welcome :)

best regards

Morten
 

·
Registered
Joined
·
21 Posts
You might check out the steering shaft. My failed on my 2005 300 Touring. What you are describing sounds similar to my symptoms.
Heydo,
Wally
 
1 - 2 of 2 Posts
Top