Chrysler 300C & SRT8 Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I've had my oil changed twice at the dealership and both times when I checked the level it was about 1/4" above full. Told them about this before they did the second oil change, but still showed overfull. In the service manual, it says to run engine for 10 mins, shut off wait 5 mins to check. When I do this stick shows right at full. But if you wait the engine keeps draining and by 15 to 20 mins its 1/4 over full. I told dealer about this and there tech said thats what happens on the hemi and thats why the service manual says to check after 5 mins. Does anyone else read over full after 20 mins or cold?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top