Joined
·
13,325 Posts
cant remember if I've posted this before, but most of these apply to various 300C models
Top Challenger Tips and Tricks
Top Challenger Tips and Tricks
tips
1 - 5 of 5 Posts
Joined
·
742 Posts
Even I have seen that one Billy-Bob ! and most day I can't find my ass. PAT
Joined
·
2,561 Posts
Good one. Thanks pal!
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
Intermittent ETC (red lightning bolt) light
UK & Europe Regional Forum2007 Chrysler 300C Diesel - 117k miles on clock My ETC light came on and the car went into limp mode. After leaving the car for about 30 mins I started the car and the light had gone out and was no longer in limp mode. Drove the car again today, the same thing happened again. Left the car for...- 2
- 138
-
Hello Old Friends!
UK & Europe Regional ForumJust thought I'd pop in and say hello to anyone who remembers me, hope you are all well!? I'm back in the fold with a new 300 SRT (luckily we can still get them down under!) Stef- 1
- 173
-
Stef · updated
-
P0335 No start. 07 CRD Tourer.
UK & Europe Regional Forum07 CRD with 81K cranked but no start yesterday. MIL came on and P0335 logged. Third attempt and it started and been ok since. Crankshaft Position Sensor was replaced under warranty back in 09. I'm guessing I need to get a new one. Any other ideas ? Searching around it seems there are two...- 8
- 667
-
dm575 · updated
-
Glowplug replacement
UK & Europe Regional ForumWent to replace #4 glowplug yesterday. Got engine nice and hot and removed old one without any problems. Went to fit new NGK replacement ( from our friendly 300C shop ) and it really didn't to want to go in to even begin the threads. A quick compare of old and new and the tip looks slightly...- 1
- 191
-
dm575 · updated
-
300C CRD 2007 - Hesitation under hard acceleration
UK & Europe Regional ForumI have a problem where my 300C is spluttering / pulling back / juddering under hard acceleration. I had the turbo actuator replaced a week ago as had the "lightning bolt" come on and when it was tested the motor had failed in the actuator. I was having problems under hard acceleration before...- 2
- 266
-
padpadpadpad · updated
Join now to ask and comment!