You need to keep holding the button up for 3 seconds after it is all the way up, this re-programs the auto up switch- it will work. It is also listed in the car's manual as aprocedure when battery is disconnected.Ken Lally said:
Window issue : auto-up not working (Moved)
The front driver-side window goes up and down, however the auto-up is not working. Auto-down on the same window works fine.
In searching historical posts I found windows that did not work altogether and and new regulators corrected the issue. This is diff though-
Anyone experience this?
K
In searching historical posts I found windows that did not work altogether and and new regulators corrected the issue. This is diff though-
Anyone experience this?
K
1 - 3 of 15 Posts
No doubt they disconnected the battery.....you will be fine...Ken Lally said:Thanks, will try tonight... I did have the car in the shop to replace the control module for the AC unit (went dead at 80mls), I guess they must have disconnected the battery then?
One correction.......you need to hold it up for 2 seconds when it is all the way up then immediatley hold the button down all the way until it is fullt down, make sure you hold the button down all the way down past the second click.Johnny Vig said:No doubt they disconnected the battery.....you will be fine...
1 - 3 of 15 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chrysler 300C & SRT8 Forums
Join the 300c forum community to discuss the Chrysler 300c, SRT8, horsepower specs, AWD system and so much more!
Full Forum Listing
Top Contributors this Month
View All
Smackeyacky
35 Replies
Curious Joe
18 Replies
magnuman
13 Replies
Recommended Communities
